ICP programming | Contours in the YZ plane
TURN PLUS attributes
In the TURN PLUS attributes, you can define settings for the
automatic working plan generation (AWG) submode.
Parameters for defining the starting point:
HC: Milling/drilling attribute
1: Contour milling
2: Pocket milling
3: Area milling
4: Deburring
5: Engraving
6: Contour + deburring
7: Pocket + deburring
14: Do not machine
QF: Cutter position
0: On the contour
1: Inside / left
2: Outside / right
HF: Direction
0: Up-cut
1: Climb
DF: Milling diameter
WF: Angle of chamfer
BR: Chamfer width
RB: Return plane
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
6
511