HEIDENHAIN 548431-05 User Manual page 341

Teach-in | Thread and undercut cycles
Internal thread and thread undercut
The machining operation consists of two steps. The Undercut DIN
76 cycle machines the undercut and thread chamfer. The
cycle then cuts the thread.
1st step
The parameters for the undercut and thread chamfer can be
programmed in two superimposed input windows.
The control determines the undercut parameters from the standard
table.
For the thread chamfer, you only need to enter the chamfer width.
The angle of 45° is the default value for the Cut-in angle WB.
Tool data:
Turning tool (for internal machining)
TO = 7 – Tool orientation
A = 93° – Tool angle
B = 55° – Point angle
2nd step
The thread cycle (longitudinal)
is defined. The control automatically determines all other values
from the standard table.
You must pay attention to the setting of the Inner thread soft key.
Tool data:
Turning tool (for internal machining)
TO = 7 – Tool orientation
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
thread
cuts the thread. The thread pitch
5
341