Cleaning And Inspecting - Arctic Cat EL TIGRE 1980 Service Manual

2
,1
--
Fig. 4-66
•
•
•
.
8096
17. Scribe a line on the shaft along th e edge of
the beari ng to aid in assembly. Loosen the
set screw on th e coll ar, drive the co llar
clockwise un til free, an d re move the bear-
ing and f lange pl ates from th e sh aft.
18. Remove the two spring pins from the outer
sprocket s, loosen th e clamp from the inner
sprocket, and press th e three sprockets o ff
th e dri vesha ft.
19. Remove the six socket-head cap screws
and lock nuts sec uring the brake disc to
th e hub; th en separate di sc and hub.
Fig. 4-67
•
•
I
l
~
•
•
-
r-1·
·~ ~
•
(
'
f~"., ~· •"---~-~
- - r }4 . .
~
.,.,
'
••
\
.
\ .,
)
.............
........_
--- ·
- ~
•
:!\.. • -
...
'"'\ ~
l
•
•
.
.
• "
•'
.
•
CLEANING AND INSPECTING
•
•
.
/
..
•
'
8193
NOTE: Whenever a part is worn excessive·
ly, cracked, defective, or damaged in any
way, replacement is necessary.
1. Thoroughly wash all metallic components
in parts cleaning solvent. Dry using com-
pressed air.
2. Wash all non-metallic components with
soap and water.
•
3. Inspect driveshaft and driven shaft for
damaged splines or stripped threads.
4. Inspect bearings for any roughness or
damage.
5. Inspect seals for any breaks or damage.
6. Inspect the track for cuts, gouges, or
broken cleats.
7. Inspect the keyways in the driven shaft and
the brake hub for wear or damage.
8. Inspect the brake disc for wear or cracks.
9. Inspect chain, sprockets, and chain ten-
sioner components for wear or damage.
10. Inspect the track drive sprockets for wear
or damage.
•
•