Arctic Cat EL TIGRE 1980 Service Manual page 33

I
d. Monitor the pressure gauge. Pressure
must not drop at a rate of more than 1 lb
per minute. .
e. If the pressure drops faster than
specified, inspect for an air leak with
soapy water or completely submerge
the pressurized engine in clean fresh
water. Repair as needed.
19. Place the magneto case into position and
secure with ei ght screws coated with LOC-
TITE LOCK N' SEAL. Place the CDI unit into
position on the magneto case and secure
wi th two bolts and washers.
Fig . 2·73
.- -
•
•
•
-·
•
A640
20. Align the marks made during disassembly;
th en secu re the stator plate with two
screws coated w ith LOCTITE LOCK N'
SEAL and lock washers. Insert the wiring
harness through th e cutout and in stall
grommet; then place the clamp into posi -
tion and secure with the screw and lock
washer.
Fig. 2·74
-
a · ~ /
• •
22. Place the starter pulley into position on the
flywheel and secure with three bolts and
lock washers. Using a spanner wrench,
tighten bolts to 0. 7 kg-m (5 ft-lb).
Fig. 2-75
'
.
'
l
\"
•
8326
23. Apply LOCTITE LOCK N' SEAL to the
crankshaft threads; then install the washer,
lock washer, and nut securing the flywheel .
Using a spanner wrench, tighten the
flywheel nut to 6.8-8.7 kg-m (49-63 ft-lb).
Fig. 2-76
"fti"k - . -
8327
24. Place an exhaust-manifold gasket on each
exhaust port making sure the metal side of
the gasket faces the cylinder; then place
A111
the exhaust manifold into position and
secure with four lock washers and nuts.
21 . Install the key in the crankshaft and slide
the flywheel onto the crankshaft making
sure the keyways match.
Tighten the nuts to 1.5-1.9 kg-m (11-14 ft-lb).
NOTE: lhe exhaust manifold spring
bracket should be on top.
•
IJ