Cleaning; Inspecting - Arctic Cat EL TIGRE 1980 Service Manual

•
-
CLEANING
1. Using parts cleaning solvent, wash grease,
dirt, and foreign matter off all parts. Dry the
parts with compressed air.
2.
If drive belt dust accumulation is present
on the stationary sheave or on the movable
sheave Duralon bushing, remove the ac-
cumu I at ion using parts cleaning solvent
only.
CAUTION
DO ruoT
use steel wool or a wire brush to clean
components huving a Duralon bushing; damage will
result ii bushing is contacted with the steel wool or
a wire bn1sh.
•
......,. m
INSPECTING
NOTE: Whenever a part is worn excessive·
ly, cracked, defective, or damaged in any
way, replacement is necessary.
1.
Inspect stationary sheave, movable
sheave, spider, and cover plate for cracks
and imperfections in the castings.
2.
Inspect the arm pins for wear or bends.
3. Inspect the Duralon bushing on the inside
of the cover plate for wear, damage, or
cracks. Measure the inside diameter of the
bushing and the outside diameter of the
stationary sheave hub. The difference
(clearance) must be less than 0.76 mm
(0.030 in.).
Fig. 4·32
'
-·
'
,
'
•
•
-
..
.
"
.
. I
8371
Fig. 4.33
8372
4. Inspect the Duralon bushing on the inside
of the movable sheave for wear, damage, or
cracks. Measure the inside diameter of the
bushing and the outside diameter of the
stationary sheave hub. The difference
(clearance) must be less than 0.76 mm
(0.030 in.).
•
Fig. 4·34
•
•
•
8369
Fig. 4.35
5. Inspect the spliing for proper compression
qualities. Spl'iing
compression must be
53
lb
@
2.375
in.
•
•
•
•