Correcting Parallelism/Offset - Arctic Cat EL TIGRE 1980 Service Manual

•
-
Fig. 4-53
J'/
/
y
x
i:
...~\
...
r-
-r
•
I
' ' '\. '\. ' ' ' > '"- T "
-
I I
I
I
072S.081
5. If either or both dimensions are other than
specified, proceed to Correcting
Parallelism/Offset section.
CORRECTING PARALLELISM/OFFSET
If dimension Y is less than or equal to dimen-
sion
X,
use· steps
1-3.
If dimension
Y
exceeds
dimension X by more than specified, use steps
4-6. If both dimensions X and Y do not f al
I
within the offset range, use steps 7-10.
1. Loosen the two cap-lock screws securing
the engine· support; loosen the two cap-
lock screws securing the engine plate
assembly.
Fig. 4-54
.
''
8299
2.
Insert a washer between the left front
engine mount and the engine support.
3. Tighten cap-lock screws; then check
parallelism/offset to ensure accuracy.
4. l!.oosen the two cap-lock screws securing
the engine support; loosen the two cap-
lock screws securing the engine plate
assembly.
5. Insert a washer between the right front
engine mount and the engine support.
68
6. Tighten cap-lock screws; then check
parallelism/offset to ensure accuracy.
Fig . 4.55
-.
.....
8300
7. Remove th e cap-lock screw and washers
securing the driven pulley to the drive n
shaft; th en remove pulley.
· ~
' ,,
8379
8. If dimensions X and Y are less than
specified, add a washer (or washers as re-
quired) between driven pulley and the
driven-shaft bearing.
9.
If dimensions X and Y are more than
specified, remove a washer (or washers as
required) from between driven pulley and
the driven-shaft bearing.
10. Install driven pulley and secure with the
cap-lock screw and washers; then check
parallelism/offset to ensure accuracy.
•
NOTE: A maximum of 1.5 mm {0.060 in.)
''float'' of the driven pulley is allowable.
I