Arctic Cat EL TIGRE 1980 Service Manual page 128

I
l
•
•
•
I
•
1. A. Slide the shock pads, front crossbrace,
and front-arm bracket onto the rai Is.
Secure the shock pads with four solid
rivets and push nuts; secure front
crossbrace and front-arm bracket with
eight bolts and lock nuts.
B. SI ide the shock pads, front crossbrace,
and front-arm bracket onto the rails.
Secure the shock pads with four solid
rivets and push nuts; secure front cross-
brace and front-arm bracket with 14
bolts and lock nuts.
2. Place the front-arm stop into position
around front arm and secure with a bolt,
two washers, and lock nut.
3. Secure the front-arm stop to the front
crossbrace with a bolt and lock nut.
Fig. 7·16
.
i
•
•
.
l
!
...
-
..
-
.
-
8128
4. Insert the spacers and four bushings into
the front arm; then secure to the front-arm
bracket with two bolts and lock nuts. Tight-
en and then torque to 3.2 kg-m (23 ft-lb).
Fig. 7·17
8127
122
5. Install the front suspension springs.
Secure with eyebolts and lock nuts. Tight-
en the lock nuts until 32 mm (1 1/4 in.) of
thread is exposed behind each lock nut.
Fig. 7·18
r·
t'
·.
\ :
...
\,
.
'
.
'
.
7 '
•
8234
6. B. Place the axles into position in the
front-arm bracket; then secure the idler
wheels to the front-arm bracket with
four cap-lock screws and six washers
making sure the idler wheels are posi-
tioned outside of the rails.
Fig. 7·19
.
----~----,.._'l
.
.
.
•
~
.
,
.
'(
,.,
/
•
/·
.
. . . . . . f
-
.
.:--
•
· 1
~
I
8410
7. Place the movable end of the shock ab-
sorber w/bush i ngs into position on the rear
arm and secure with a bolt and lock nut.
Tighten to 3.2 kg-m (23 ft-lb). Make sure the
wider flange of the rear arm is positioned
upward.
I
'
j
n
. .