Table of Contents
Advertisement
l
1.
Secure the hub to the brake disc with the
six socket-head cap screws and lock nuts.
~
-.
_,,~
Fig
.
4·69
.,
I
.
'
•
.
.
.
.
•
(
•
'
'
.
.
~--
•
.
.
_:
.
..
-~..,,..··
.
.
..
.
.
.
l
J
'
..
,
.
1'
/
/'
:.--
8193
2.
Assem
bl
e
the
driveshaft components
(sprocket
s,
flange
plates,
bearing, collar,
clamp,
and spring pins) noting the scribed
mark
for
proper bearing placement. Do not
tig
hten the collar at this time. Place track
into
position
.
3.
Pos
ition
driveshaft
between
track so
sp
li ned end of the shaft is on MAG
side.
Fig. 4-70
.
,.
•
4.
Lift track and driveshaft assembly into
position; then push splined end of shaft
through its mounting hole in chain case.
5.
Swing PTO end of driveshaft up; then align
holes in the flange plates with holes in tun-
nel. Place the cable and drive adaptor into
position.
6.
Insert three bolts from the inside of the tun-
nel through flange plates, tunnel, and drive
adaptor. Secure with three lock nuts.
Tighten to 2.2-2.5 kg-m
(16-18
ft-lb).
Fig. 4·71
8266
7.
Slide MAG-side bearing onto shaft (inner
race flange must be positioned toward
drive chain); then install seal and flange
plate. Secure with three bolts and lock
nuts. Tighten to 2.2-2.5 kg-m
(16-18
ft-lb).
8.
Place the lower sprocket onto splines.
Secure with a cap-lock screw (coated with
LOCTITE LOCK N' SEAL) and washer. DO
NOT tighten at this time.
9.
Install key into the driven shaft brake disc
keyway; then install the collar.
10. Install the PTO-side bearing w/collar and
flange plates on the driven shaft; do not
tighten collar at this time. Place the driven
shaft into position making sure the brake
disc and flange plates are properly posi-
tioned. Secure with three bolts and lock
nuts. Tighten and then torque to 2.2-2.5
kg-m
(16-18
ft-lb).
Fig.
4·72
--
~
-~
8311
11.
On the MAG-side driven shaft, install
the
bearing, seal, and flange plate and
secure
with three bolts and
lock
nuts.
Tighten to
2.2-2.5 kg-m
(16-18
ft-lb).
•
Hide quick links:
Advertisement
Chapters
Table of Contents
