Output Settings - Mantracourt T24-ACMi-SA User Manual

Output Settings

Here you can change various settings that influence the output from the module.
Items you can change:
Duplicate
Min Interval
Gross Text
Net Text
Print On Error
Mantracourt Electronics Limited
Whether to produce the same output twice each time an output is triggered.
Useful, for example, with a printed output where a customer requires a receipt.
Minimum time allowed between triggered outputs entered in milliseconds.
Triggers arriving within this time since the previous trigger will be ignored.
Example: You may want to limit printouts to once every 10 seconds. By setting
the Min Interval to 10000 the printouts would be limited to once every 10
seconds even though the printouts were requested at a much faster rate.
Enter text to replace the <GN> token with when the module is in gross mode.
Enter text to replace the <GN> token with when the module is in net mode.
Whether to trigger an output when any input module fails to deliver new data
within the timeout period.
Example: Data arrives every 5 minutes which is used as input 1 (<V1>). This
same data tag is used to trigger a printout. Normally if the data fails to arrive
the printout would not get triggered. By setting this property a printout would
be triggered when the data failed to arrive (Within the timeout period for that
input) and the values would show ------- instead of the numeric value when
<V1> is decoded. This would indicate to the user that there is a problem.
285
T24 Telemetry User Manual