T24-ANTA
This antenna is designed to be attached to a flat surface inside product enclosures made from plastic or fibre-
glass. It is intended to be directly connected to the radio module.
Mounting
Products containing this type of antenna should be oriented so that the antenna long axis is vertical during
normal operation if possible. Antenna feeder cable should be arranged to lie along the ground plane section,
allowing the feeder to run close to the active element will adversely affect performance.
100 mm UFL cable included.
The PCB requires 3.0 mm Clearance on all edges, this also applies to the RF window.
The antenna feeder cable, or any other cables or wires, must not be routed over or near the cross hatched area
shown below as this will affect range.
Specification
Gain: 3.0 dBi
Type: Inverted F Printed circuit antenna
Connection: 100 mm cable with UFL connector
Mantracourt Electronics Limited
64 mm
58 mm
412
T24 Telemetry User Manual