Connections; T24-Wss; Power; T24-Wssp - Mantracourt T24-ACMi-SA User Manual

Connections

T24-WSS

Power

Power can be supplied by fitting two D cell alkaline 1.5 V batteries or the module can be supplied from an
external 5 Vdc to 18 Vdc source. The module will switch to the external supply in preference providing a battery
backup.
In both cases you need to fit the JP1 power jumper to supply power to the transmitter module.
When powered from the external DC source the LED will illuminate. The cable for the external supply should be
routed into the cable gland at the bottom of the case, up past the battery holder and into the two part connector
terminals shows in the diagram below.
For battery information please refer to

T24-WSSp

Power
Power is supplied by fitting two D cell alkaline 1.5 V batteries.
You may need to fit the JP1 power jumper to supply power to the transmitter module.
The LED does not illuminate in this module.
For battery information please refer to

Configuration

The T24 Toolkit provides a means of simple configuration and calibration of the transmitter module along with
useful tools to aid integration.
Launch the T24 Toolkit software application and pair to this module to enable the connection to the Toolkit to
allow configuration to take place.
Mantracourt Electronics Limited
Power J umper J P1
0V
+Supply
LED
Appendix D – Battery Selection
Power J umper J P1
LED
Appendix D – Battery Selection
See Common Toolkit Pages - Home
2 X D Cell Batteries
2 X D Cell Batteries
149
T24 Telemetry User Manual