T24-WSSp
The T24-WSS is designed to be attached to a moving boom and uses a pivot design to ensure that the sensor
remains upright regardless of the angle of the boom. The pivot bar is threaded for M8.
Boom Mounting
Remove the mounting pivot bar from the wind speed sensor. You may have to remove the split pin/cotter
pin first.
Determine the position to mount the pivot bar by following these guidelines.
a.
Install the mounting pivot bar on the same side of the boom as the cabin mounted display.
b. Install the mounting pivot bar perpendicular to the boom.
c.
Install the mounting pivot bar at the highest point possible where the sensor will be free to rotate at all
boom angles.
Mantracourt Electronics Limited
155
T24 Telemetry User Manual