Advanced I/O
This module does not provide calibration, as such, because it is factory calibrated. However, on this page you can
adjust the gain to provide different output Types.
Custom Output Type
Items you can change:
Gain
Offset
Reset Counter Data Tag
Advanced Settings
Mantracourt Electronics Limited
Default is 1. If the gain value is set the output value of the module will be
multiplied by the gain before transmission. This setting only applies to
Frequency; Time & RPM outputs not the counter.
Default is 0. If the offset value is set the output value of the module will be
multiplied by the gain and the offset subtracted before transmission. This
setting only applies to Frequency; Time & RPM outputs not the counter.
If using the counter output the data tag specified in this field will cause the
counter in the T24-PA to reset to zero whenever a data packet with this data tag
is detected. Data providers can be produced by other transmitter modules, T24-
HA or custom software
431
T24 Telemetry User Manual