Errors; Special Modes - Mantracourt T24-ACMi-SA User Manual

Errors

Displayed on handheld LCD.
Error 1
Error 2
Overload

Special Modes

T24-HR label actually has 6 keys but only 2 are marked. The following modes require some of the
unmarked keys.
Pair
System Zero
Mantracourt Electronics Limited
The transmitter module has a strain gauge input and is in shunt calibration mode.
An external module has placed the transmitter module in Shunt Calibration mode
so rather than display a misleading reading this error is displayed instead.
Modules such as the T24-SA support this error type.
Input integrity error. The transmitter module has found a problem with the input.
There may be open or short circuits. Rather than display a misleading reading this
error is displayed instead.
Only certain transmitter modules support this error such as the T24-SA.
The overload limit set by the user has been exceeded.
The handheld has the ability to configure a transmitter module to match the
handheld's own radio channel and group key settings.
Ensure that the transmitter module is unpowered for at least 10 seconds.
Locate the upper left key by feeling for a slight bump on the label.
Press and hold this key for 5 seconds until PAIRING appears on the LCD.
Release the key and apply power to the transmitter module.
The amount of time you have to reapply power to the transmitter module can be
set by PairDuration in the T24 Toolkit when connected to the T24-HR. This
defaults to 5 seconds.
The handheld has the ability to perform a system zero on a remote transmitter
module. This may be useful after installing new modules and enables system zero
to be set without the need for a PC/laptop and T24 Toolkit.
Set the handheld to view the desired transmitter module by using the Next key.
Locate the upper right key and lower right key by feeling for slight bumps on the
label.
Press and hold these keys for around 8 seconds until ZERO appears on the LCD.
Release the keys and the display should then show the zeroed reading.
This system zero is performed at the transmitter module and is stored through
power cycling.
207
T24 Telemetry User Manual