Sensor Status 2 (Sensor Status 2) - Single Bit; Sensor Status 3 (Sensor Status 3) - Single Bit; Wire Stick Workpiece (Wire Stick Workpiece) - Single Bit; Parameter Selection Internally (Internal Parameter Selection) - Single Bit - Fronius TPS/i User Information

If there is no sensor in the system, the signal is set to High.
Additional information for TWIN systems:
The signal is output separately for both process lines.
Sensor Status 2 This signal indicates the status of the wire end option 4,100,879,CK.
(sensor status 2)
- Single Bit
Signal level
High
Low
The signal is output as soon as the sensor of the option is detected in the system.
If there is no sensor in the system, the signal is set to High.
Additional information for TWIN systems:
The signal is output separately for both process lines.
Sensor Status 3 This signal indicates the status of the wire end option 4,100,878,CK.
(sensor status 3)
- Single Bit
Signal level
High
Low
The signal is output as soon as the sensor of the option is detected in the system.
If there is no sensor in the system, the signal is set to High.
Additional information for TWIN systems:
The signal is output separately for both process lines.
Wire stick work- The signal is High if a wire stick is detected on the workpiece. This signal is always out-
piece (Wire stick put regardless of other settings.
workpiece) -
Single Bit Additional information for TWIN systems:
The signal is set to High as soon as one of the two wire electrodes sticks.
Parameter selec- This signal indicates whether the parameter selection has been set to "internal".
tion internally
(Internal para- This setting can be applied:
meter selection) - -
Single Bit -
34
Description
Wire electrode present
No wire electrode present
Description
Wire electrode present
No wire electrode present
Using the Working mode signal/internal parameter selection or
On the power source itself: Defaults/Interface setup/Welding parameter.