Arrangement Of Command And Response Tables; Sis Command And Response Table For Matrix Switcher Commands; Sis Command And Response Table For Transmitter Endpoints; Sis Command And Response Table For Receiver Endpoints - Extron electronics XTP II CrossPoint 1600 Setup Manual

Arrangement of Command and Response Tables

The following pages present five command and response tables,
each defining a subset of SIS commands and their responses, with
examples where appropriate. The following tables are presented:
SIS Command and Response Table for Matrix Switcher
•
Commands, starting on the next page — SIS commands to
control and monitor the XTP II CrossPoint matrix switcher itself
and specific input and output boards.
SIS Command and Response Table for Transmitter
•
Endpoints, starting on page 37 — SIS commands to
control and monitor XTP transmitter endpoints from the matrix
switcher.
SIS Command and Response Table for Receiver
•
starting on page 39 — SIS commands to control and monitor
XTP receiver endpoints from the matrix switcher.
SIS Command and Response Table for Switching
•
Transmitter
commands to control and monitor the XTP T USW 103 and
XTP T USW 103 4K switcher endpoint from the matrix switcher.
SIS Command and Response Table for IP-Specific
•
Commands, starting on page 45 — SIS commands to
control and monitor the IP interface of the XTP II CrossPoint
matrix switcher.
Endpoint, starting on page 42 — SIS
XTP II CrossPoint Series • Remote Control
Endpoints,
25