Configure The Ap Parameters - JRC NTG337-EL0 Instruction Manual

Fwa system
Table of Contents

Advertisement

5.9. Configure the AP parameters

5.9.1. AP Local management tool
5.9.1.1. Configure the AP network parameters
Use the AP Local Management Tool to set the network parameters.
These settings enable the OpS to connect to the AP.
Perform the following setup procedure from the AP setup screen on the AP Local Management
Tool.
Step 1: OpS Frame Priority: Set the OpS frame priority.
Step 2: User Frame Priority: Set the user frame priority.
Step 3: OpS Frame VLAN-ID: Set the OpS frame Vlan-ID.
Step 4: Radio frequency: Set the radio frequency.
Step 5: AP IP Address: Set the AP IP address.
Step 6: Subnet mask: Set the subnet mask.
Step 7: Default gateway: Set the default gateway.
Step 8: Trap Des, IP Add. 1: Set the "Reg./Not" and trap destination IP address 1. Set
"Reg." or "Not" and set an IP address for trap destination IP address 1. If
necessary, you can also set Trap Des, IP Add. 2 and Trap Des, IP Add. 3.
Step 9: Ether-IF 1: Set whether to use Ether-IF 1. If necessary, you can also set Ether-IF
2.
Step 10: Click the Setup button.
Step1
Step2
Step3
Step4
Figure 5-22 Configure the AP network
5-67
Step5
Step6
Step9
Step10
Step7
Step8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntg335-el0Nt337-xl2Ntg337-xl0Ntg337-el2Ntg335-el2

Table of Contents