Table of Contents
Advertisement
(4) Mounting spacer (d)
-
Mount the spacer on the Ethernet cable
-
Make sure that the spacer is fully inserted in the small Lid of the WT (Figure 7-50).
・ Insert the spacer into the small window fully. Partial insertion of the spacer will spoil the
waterproofing effect.
(5) Mounting cold-shrinkable tube (a)
-
Place the cold-shrinkable tube on the spacer and small Lid (Figure 7-51).
-
Butt the end of the cold-shrinkable tube against the base of the small Lid. Pulling white
spiral tube (e) to the very edge of the cold-shrinkable tube eases the subsequent
procedure (Figure 7-51).
-
Pull the spiral tube to mount the edge of the cold-shrinkable tube on the small Lid (Figure
7-52). Make sure that there is no gap between the cold-shrinkable tube and the base of
the small Lid and between the spacer and the small Lid.
-
Pull the spiral tube to mount the cold-shrinkable tube, paying attention so the spacer is
not lifted (Figure 7-53 and Figure 7-54). Make sure that the spacer is not protruded from
the cold-shrinkable tube. The top of the cold-shrinkable tube should be 5 mm or less from
the top of the spacer.
Spacer
(d)
Inserted
Figure 7-49
Figure 7-51
Figure 7-53
Figure 7-52
Figure 7-54
7-140
Figure 7-50
Advertisement
Table of Contents
