5.9.2. Register the AP ID number to OpS
Connect the OpS to the target AP and specify the setup parameters.
Procedure
Step 1: In the OpS, select the AP Parameter Setup/Control screen.
Step 2: AP ID Number: Set the AP ID number and click the Set button.
Step 3: Upstream Arbi. BW: Set the upstream arbitration bandwidth.
Step 4: AP trans. Level: Set the AP transmission level (You can set only +14dBm) and
click the Set button.
Step 5: AP Reg. Status: Set the AP registration status to Registered and click the Set
button.
Step 6: RFU transmission: Set the RFU transmission to Enable and click the Set button.
Step 7: Modulation Method: Set the modulation method to QPSK, 16QAM or Mixed, and
click the Set button.
Step1
Step3
Step5
Figure 5-30 Register the AP to OpS
5-71
Step2
Step4
Step6