Adjusting The Direction Of The Wt - JRC NTG337-EL0 Instruction Manual

Fwa system
Table of Contents

Advertisement

6.7. Adjusting the Direction of the WT

To adjust the direction of the WT antenna, use the Antenna direction adjustment tool together with
the WT Local Management Tool.
Step1 Connecting the WT Local Management Tool and display the Receiving Level.
-
See Subsection 6.7.1
Step2 Rough adjustment
Install the Antenna direction adjustment tool.
-
See Subsection 6.7.2
-
Step3 Fine adjustment
See Subsection 6.7.3
-
Step4 Verification
-
After adjust the direction, use the WT Local Management Tool to final check the receive
level.
If the receive level value is within the standard range, the procedure for adjusting the
antenna direction has been completed.
If the receive level value is lower than a standard value, you need to perform Step 3 again.
-
Exit the WT Local Management Tool, and remove the Ethernet cable from the WT
adapter.
-
Remove the Antenna direction adjustment tool.
6-89

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntg335-el0Nt337-xl2Ntg337-xl0Ntg337-el2Ntg335-el2

Table of Contents