System Example Point To Multipoint System - JRC NTG337-EL0 Instruction Manual

10.

System example Point to Multipoint system

An example point-to-multipoint system configuration is shown in Figure 10-1.
The settings of this system configuration are as follows:
AP setting: Table 10-1
WT setting: Table 10-2
VLAN switch setting: Figure 10-2
IP :192.168.0.1
Sub:255.255.255.0
DC -48V C able
IFU
DC-48V
Connector
AC-DC
Converter
LAN C able
AC100∼240V
TypeA or TypeC
L2SW
WT1 WT2WT3
OpS
AC100∼240V
TypeA or TypeC
LAN Cable
LAN C able
OpS PC Test PC
IP :192.168.0.120 IP :192.168.2.100
Sub:255.255.255.0 Sub:255.255.255.0
IFU-RFU Cable
RFU
tripod
Management Cable
(Serial Cable)
Maintenance Tool
Figure 10-1 System example Point to Multipoint
VID:2
WT1
non-transparent
IP:192.168.1.100
WT Adapter
LAN Cable
AC Adapter
tripod
AC100∼240V
TypeC
VID:50
WT2
non-transparent
IP:192.168.1.100
WT Adapter
LAN Cable
AC Adapter
tripod
AC100∼240V
TypeC
VID:100
WT3
non-transparent
IP:192.168.1.100
WT Adapter
LAN Cable
AC Adapter
AC100∼240V
TypeC
10-157
LAN Cable
Test PC
IP :192.168.2.101
Sub:255.255.255.0
LAN Cable
Test PC
IP :192.168.2.102
Sub:255.255.255.0
LAN Cable
only Setup Test PC
IP :192.168.2.103
Sub:255.255.255.0
Maintenance Tool
IP :192.168.1.101
Sub:255.255.255.0