JRC NTG337-EL0 Instruction Manual page 57

Contents
Interface
Connector shape
Pin assign
Contents
Interface
Shape
Pin assign
Contents
Interface
Shape
Pin assign
Contents
Shape
Applicable Connector
Contents
Applicable outer diameter
Contents
Applicable Cable
Applicable terminal
Contents
Pin assign
Name
Applicable Connector
name
(a) ETHER1 connector
Connect the outside network
The user signal distributed by internal SW-HUB,and output to ETHER1 and
ETHER2. ETHER1 is used usually.
100BASE-Tx
RJ-45
See Figure 3-9
(b) ETHER2 connector
Connect the outside network
The user signal distributed by internal SW-HUB,and output to ETHER1 and
ETHER2. ETHER1 is used usually.
100BASE-Tx
RJ-45
See Figure 3-9
(c) MNT(maintenance) connector
Connect the Local management tool
Serial
RJ-22
See Figure 3-10
(d) ANT terminal connector
Connect the AP-IFU with the coaxial cable.
N-Type Jack for Coaxial
N-Type Plug for Coaxial
(e) Ethernet cable inlet
Insert the Ethernet cable into the rubber bushing.
Φ5.5mm or less
(f) FG terminal
Connect the ground wire.
Ground wire more than 1.5□mm
FG terminal M4nut.
(g) Power cable connector
Connect the power cable.
See Figure 3-11
NRW-203-RM-ULCSATUV (Nanaboshi Electric MFG Co.,LTD.)
NRW-203-PF8-ULCSAUV (Nanaboshi Electric MFG Co.,LTD.)
(This connector is supplied with AP-IFU.)
3-34