Opening And Closing The Ap-Ifu Cover - JRC NTG337-EL0 Instruction Manual

5.2.4.3. Opening and Closing the AP-IFU Cover

To open the cover:
(1) Loosen the special screws (a) to (d) to open the cover as shown in Figure 5-13.
(2) Keep the cover stay open using the stopper (e) as shown in Figure 5-13.
To close the cover:
(1) Replace the stopper (e) on the main unit as shown in Figure 5-13
(2) Close the cover and tighten the special screws (a) to (d) as shown in Figure 5-13.
a
c
Use a T25 torx driver to open the AP-IFU cover.
・ When opening the AP-IFU cover, make sure that the four special screws are loosened
completely. Forcing open the cover may damage it.
・ After you opened the AP-IFU cover, make sure to secure it using the stopper. Otherwise,
you may get hurt. To close the cover, be sure to return the stopper to the original position.
・ If it is difficult to tighten the four special screws of the AP-IFU cover, adjust the locations of
the screw holes (support the cover and align the top of the cover to that of the chassis)
and tighten the screws. Forced tightening of the screws may damage the cover and
screws.
・ When closing the cover, be careful not to nick cables.
b
d
Figure 5-13 Opening and Closing the AP-IFU Cover
5-54
⑤
e