Connecting Cables From The Ap-Ifu To External - JRC NTG337-EL0 Instruction Manual

Fwa system
Table of Contents

Advertisement

5.5. Connecting Cables from the AP-IFU to external

Step1 Connect four cables to the AP-IFU: a coaxial cable (with an N-type plug),
Ethernet cable, outdoor power supply cable, and ground wire.
(f) Power cable
connector
(j) Clamp
(e) Ethernet cable
inlet
Cable contents
Interface
Connector shape
Pin assign
Cable type
Range of applicable outer
diameter
(i) Clamp
(g) FG terminal
(M4nut)
(3) Ground wire
(More than 1.5□mm)
(2) Outdoor power supply cable
Figure 5-19 Connecting Cables to the AP-IFU
(1) Ethernet Cable
Connect the (a)ETHER1 connector.
Fix the cable by using (h), (i), (j) clamp in the AP-IFU.
Connect the external network through the (e)Ethernet cable inlet.
100BASE-Tx
RJ-45
ETHER signal(MDI)
Ethernet cable for outdoor
Φ5.5mm or less
(h) Clamp
Use a T25 torx driver to open the AP-IFU cover
5-59
(a) ETHER1
(b) ETHER2
(c) MNT
(d) ANT terminal connector
Figure 5-18
To AP-RFU(see
)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntg335-el0Nt337-xl2Ntg337-xl0Ntg337-el2Ntg335-el2

Table of Contents