Configure The Wt(Slave) - JRC NTG337-EL0 Instruction Manual

Fwa system
Table of Contents

Advertisement

7.4. Configure the WT(slave)

Change the WT's mode from P-MP to P-P(slave).
On the Setup screen in the WT Local Management Tool (Slave in P-P mode, Administrator),
specify the settings in the following procedure:
Step 1: Select the "Slave" setup tab.
Step 2: Specify the settings under Setup for Setup Parameters.
-
System ID Number: Set the system ID number.
-
Serial number at opposite WT: Set the serial number at the opposite WT.
-
Encryption Parameter: Set the encryption parameter.
-
Trans. Level: Set the transmission level.
-
Interface Class: Set the interface class to AUTO or 10BASE.
-
Radio Frequency: Set the radio frequency.
Step 3: Set the Network configuration for Setup Parameters.
-
AP IP Address: Set the AP IP address.
-
Subnet mask: Set the subnet mask.
-
Default gateway: Set the default gateway.
-
ARP Request: Set the ARP request to ON or OFF.
Step 4: Click the Setup button.
Step1
Step2
Figure 7-3 Configure the WT(slave)
7-115
Step3
Step4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntg335-el0Nt337-xl2Ntg337-xl0Ntg337-el2Ntg335-el2

Table of Contents