Configure The Wt(Master) - JRC NTG337-EL0 Instruction Manual

Fwa system
Table of Contents

Advertisement

7.3. Configure the WT(master)

Change the WT's mode from P-MP to P-P(matser).
On the Setup screen in the WT Local Management Tool (Master in P-P mode, Administrator),
specify the settings in the following procedure:
Step 1: Select the "Master" setup tab.
Step 2: Specify the settings under Setup for Setup Parameters.
-
System ID Number: Set the system ID number.
-
Serial number at opposite WT: Set the serial number at the opposite WT.
-
Encryption Parameter: Set the encryption parameter.
-
Trans. Level: Set the transmission level.
-
Modulation Method: Set the modulation method to QPSK, 16QAM, or AUTO.
-
Interface Class: Set the interface class to AUTO or 10BASE.
-
Radio Frequency: Set the radio frequency.
-
Reg. Status: Set the registration status to Reg.
Step 3: Set the Network configuration for Setup Parameters.
-
IP Address: Set the IP address.
-
Subnet mask: Set the subnet mask.
-
Default gateway: Set the default gateway.
-
Trap Des. IP Add1: Set "Reg." or "Not" and trap destination IP address 1. As required,
you can also set Trap Des. IP Add2, and Trap Des. IP Add3.
-
OpS Frame Priority: Set the OpS frame priority.
-
OpS Frame Vlan-ID: Set the OpS frame Vlan-ID.
-
ARP Request: Set the ARP request to ON or OFF.
Step 4: Click the Setup button.
Step 5 Make a clock setting in Setup Parameters2 and click the Setup button.
Step 6 Set RFU Transmission (Enable) in Setup Parameters3 and click the Execute button.
7-113

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntg335-el0Nt337-xl2Ntg337-xl0Ntg337-el2Ntg335-el2

Table of Contents