Overview - JRC NTG337-EL0 Instruction Manual

Fwa system
Table of Contents

Advertisement

1. OVERVIEW

JRC FWA SYSTEM is a broadband wireless point-to-multipoint communication system
operating at 24-26 GHz that provides high-speed IP access. The 80Mbps/40Mbps wireless
transmission rate is available on one frequency channel having the RF bandwidth of 26MHz.
The wireless transmission rate depends upon the selected modulation system
(16QAM/QPSK), which is controlled for each subscriber terminal to be adapted with the
radio propagation path environment such as the distance from the access point and rainfall
conditions. The maximum throughput (average data transmission rate of an Ethernet
frame) received and transmitted by an access point is 46Mbps.
The data transmissions in radio channel are encrypted by different keys for each subscriber
terminal to ensure sufficient security. The system can deal with the subscribers fairly in
assigning the bandwidth, regardless of the distances of subscriber terminals from the base
station.
1.1. FCC Notice
FCCID: CKENTG335-EL0, CKENTG335-EL2, CKENTG337-EL0, CKENTG337-EL2
CKENTG337-XL0, CKENT337-XL2
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
1-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntg335-el0Nt337-xl2Ntg337-xl0Ntg337-el2Ntg335-el2

Table of Contents