Measure The Packet Loss Rate - JRC NTG337-EL0 Instruction Manual

Fwa system
Table of Contents

Advertisement

6.13.2.

Measure the packet loss rate

Connect the OpS terminal to an AP and measure the packet loss rate with the following
procedure:
Step 1: Click the Testing tab.
Step 2: Select a WT from the Select WT ID list.
Step 3: Select the "Packet Loss Rate measurement (with Loop back, 10msec)" check
box.
Step 4: Specify the following settings, and click the Execute button to start the test.
-
Display Interval : 4 seconds
Modulation Method (only Adaptive) : Select the current modulation method
-
(check the WT Operation Status List in the OpS).
Retry Time : 5 minutes
-
Step 5: Perform a time measurement and check the Packet Loss Rate column.
Step 2
Step 3
Figure 6-55 Measure the packet loss rate
Step 1
Step 4
6-109
Step 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NTG337-EL0 and is the answer not in the manual?

This manual is also suitable for:

Ntg335-el0Nt337-xl2Ntg337-xl0Ntg337-el2Ntg335-el2

Table of Contents