Rigid Tapping - Cycle84 - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

3.
4.
9.4.6

Rigid tapping - CYCLE84

Programming
CYCLE84 (RTP, RFP, SDIS, DP, DPR, DTB, SDAC, MPIT, PIT, POSS, SST, SST1, AXN, 0, 0, VARI, DAM, VRT)
Parameters
Parameter Data type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
DTB REAL
SDAC INT
MPIT REAL
PIT REAL
POSS REAL
SST REAL
SST1 REAL
AXN INT
PSYS INT
PSYS INT
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
Press this softkey to open the window for CYCLE83. Parameterize the cycle as desired.
Confirm your settings with this softkey. The cycle is then automatically transferred to the program
editor as a separate block.
Description
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Final drilling depth relative to the reference plane (enter without sign)
Dwell time at thread depth (chip breakage)
Direction of rotation after end of cycle
Values: 3, 4 or 5 (for M3, M4 or M5)
Thread lead as a thread size (signed):
Range of values 3 (for M3) to 48 (for M48); the sign determines the direction
of rotation in the thread
Thread lead as a value (signed)
Range of values: 0.001 ... 2000.000 mm); the sign determines the direction of
rotation in the thread
Spindle position for oriented spindle stop in the cycle (in degrees)
Speed for tapping
Speed for retraction
Tool axis
Values
Internal parameter; only the default value 0 is possible
Internal parameter; only the default value 0 is possible
: 1: 1st axis of the current plane
1)
2: 2nd axis of the current plane
3: 3rd axis of the current plane
135