How To Upgrade Bt Cradle Firmware - CipherLab 2560 User Manual

HOW TO UPGRADE BT CRADLE FIRMWARE

1) Connect the interface cable, RS-232 or USB, between cradle and your computer.
For USB Virtual COM, you may need to install its driver first!
2) Connect the power supply cord from the cradle to a proper power outlet.
3) Refer to 3.1.1 Connect to Cradle
Read the MAC address label located at the back of the cradle.
4) Read the following barcodes in sequence to configure the scanner to use RS-232 as
download interface.
Or, read the following barcodes in sequence to configure the scanner to use USB
Virtual COM as download interface.
5) Read the following barcodes in sequence for the cradle to enter the download mode.
The Communication LED on the cradle will be flashing red to indicate it is ready for
downloading.
6) Run the download utility "ProgLoad.exe" on your computer.
for the target scanner to connect to the cradle.
Enter Setup
Activate Cradle
Enter Setup
Activate Cradle
USB Virtual COM
Enter Setup
Download Cradle
CPU Firmware
Appendix I Firmware Upgrade
RS-232
Update
Update
Update
215