Example - CipherLab 2560 User Manual

2560 Series Barcode Scanner
#@TRIGOFF<CR>
Purpose To disable the software trigger
Remarks
"0x23" + "0x40" + "0x54" + "0x52" + "0x49" + "0x47" + "0x4f" + "0x46" +
"0x46" + "0x0d"
#@TRIGON<CR>
Purpose To enable the software trigger
Remarks
"0x23" + "0x40" + "0x54" + "0x52" + "0x49" + "0x47" + "0x4f" + "0x4e" +
"0x0d"
#@RDSN<CR>
Purpose Read serial number
Remarks
"0x23" + "0x40" + "0x52" + "0x44" + "0x53" + "0x4E" + "0x0D"

EXAMPLE

You may run HyperTerminal.exe on the host computer to send serial commands to the
barcode scanner via RS-232, USB Virtual COM or BT SPP.
For the scanner to stop immediately –

D
For the scanner to resume working –

E
For the scanner to change the beeper to medium volume and beep –

#@101011<CR>
#@////<CR>
For the scanner to change the beeper to minimal volume and beep –

#@101010<CR>
#@////<CR>
For the scanner to change the beeper frequency to 8 kHz (for Good Read Beep only)

and beep –
#@101001<CR>
#@////<CR>
For the scanner to change the beeper length to longest (for Good Read Beep only)

and beep –
#@101008<CR>
#@////<CR>
For the scanner to save the settings, send the serial command "#@109999" –

#@101011<CR>
#@109999<CR>
218
User Guide
Enter Setup