Disable Authentication Or Use Random Pin - CipherLab 2560 User Manual

DISABLE AUTHENTICATION OR USE RANDOM PIN

In the configuration mode, read the barcode below to disable authentication (= No PIN)
or use a random PIN for authentication.
Note: When using BT HID, some device driver may not support pre-defined PIN code for
authentication. In this case, make sure you have the scanner set to "No PIN or use
random PIN" before pairing. While pairing, the host PIN code will be displayed on
the computer screen.
Use Random PIN
When the target device is set to use a random PIN for authentication, wait until the random PIN is
displayed on the target device while pairing, and then input the matching PIN code on the scanner.
Note: Follow the steps below to enter the matching PIN on the scanner. There is no need
to enter the configuration mode!
1. Read one of the barcodes to specify the PIN code, in decimal or hexadecimal.
2. Read the "Decimal
228 for the desired digits or character string.
Read the "Clear PIN Code" barcode first if you need to re-input the PIN.
Value" barcode on page 227 or the
Update
Appendix IV
*No PIN or
use random PIN
Enter PIN in
Hexadecimal...
Enter PIN in
Decimal...
"Hexadecimal Value" barcode on page
Clear PIN Code
Abort
Numeral Systems
231