Change Interface - CipherLab 2560 User Manual

3.1.2 CHANGE INTERFACE

If you want to change the interface cable of cradle, use one of the scanners to configure
the interface-related settings and it will pass the new settings to the cradle, which will
then initialize and pass the settings to any other connected scanners.
1) Have the scanner read the MAC address label at the back of the cradle.
2) Within two minutes, connect the interface cable between the cradle and your
computer. For USB Virtual COM, you may need to install its driver first!
3) The scanners will connect to your computer via the cradle.
4) Have one scanner read the "Enter Setup" barcode to enter the configuration mode.
5) Have the scanner read the desired interface barcode and configure its related
settings –
"Activate Keyboard Wedge & Select Keyboard Type"

"Activate RS-232"

"Activate USB HID & Select Keyboard Type"

"Activate USB Virtual COM" (or "Activate USB Virtual COM_CDC")

6) Have the scanner read the "Update" barcode to exit the configuration mode.
7) After the scanner
interface-related settings to the cradle.
8) Upon receipt of the new settings, the cradle will initialize itself.
9) Updated with new settings, the cradle will pass the settings to other connected
scanners.
resumes connection
Chapter 3 Setting up a WPAN Connection
with the cradle,
Update
it will pass the
103