Table of Contents
Advertisement
2560 Series Barcode Scanner
BT CRADLE SETUP BARCODES
Config<CR>
Purpose
To configure cradle.
Here is the setup barcode for this serial command:
Remarks
A list of the current settings will be displayed. Run HyperTerminal.exe on your
computer and change the settings one by one.
DefaultSetting<CR>
Purpose
To restore the default settings.
Here is the setup barcode for this serial command:
SingleConnection<CR>
Purpose
To allow only one scanner connecting to the cradle.
Here is the setup barcode for this serial command:
MultiConnection<CR>
Purpose
To allow up to seven scanners connecting to the cardle.
Here is the setup barcode for this serial command:
UseOnePortforAll<CR>
Purpose
To use one Virtual COM port for all whenever connecting the cradle to PC via USB.
This setting requires you to connect one cradle at a time, and will facilitate
configuring a great amount of cradles via the same Virtual COM port (for
administrators' or factory use).
Here is the setup barcode for this serial command:
220
User Guide
Config
DefaultSetting
SingleConnection
MultiConnection
UseOnePortforAll
Enter Setup
Hide quick links:
Advertisement
Table of Contents
