Alternate Mode - CipherLab 2560 User Manual

1.6.6 ALTERNATE MODE

The scanner will start scanning once the trigger is pressed
The scanning won't stop until you press the trigger again.

1.6.7 AIMING MODE
The scanner will aim at a barcode once the trigger is pressed, and start scanning when
the trigger is pressed again within one second.
The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout

expires.
Aiming Timeout
You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.
1) Read the barcode above to specify the time interval before aiming ends. (It is set to 1
by default.)
2) Read the "
Decimal Value
scanner to automatically shut down after idleness for 10 seconds.
3) Read the "Validate" barcode on the same page to complete this setting.
Chapter 1
" barcode on page 227. For example, read "1" and "0" for the
Understanding the Barcode Scanner
Alternate Mode
Aiming Mode
Aiming Time-out
after 1~15 sec.
(*1)
Update
41