Firmware Upgrade; How To Upgrade 1564 Firmware; Using 3656 - CipherLab 1564 User Manual

FIRMWARE UPGRADE

You can only upgrade firmware of one scanner at a time. For example, you must turn off
each of the rest 1564 scanners when there is more than one scanner connected to your
computer.
Note: In case it fails downloading due to low battery, make sure the targe scanner is
loaded with good battery and the battery charge is enough.

HOW TO UPGRADE 1564 FIRMWARE

USING 3656

1) Connect the interface cable, RS-232 or USB, between 3656 and your computer.
Connect the power supply cord from 3656 to a proper power outlet.
If you are using USB Virtual COM for the first time, you must install its driver from
the CD-ROM.
2) Refer to 3.1.1 Connect to 3656
Read the "Set Connection" label first, and then the "Serial Number" label. Both labels
can be located at the back of 3656.
3) Read the following barcodes in sequence to configure the scanner to use RS-232 as
download interface.
Or, read the following barcodes in sequence to configure the scanner to use USB
Virtual COM as download interface.
for the target scanner to connect to 3656.
Enter Setup
Activate 3656
Appendix I
RS-232
115200 bps
Update
Update
231