Auto-Sense Mode - CipherLab 2560 User Manual

1.11 AUTO-SENSE MODE

Auto-sense is only available when the scanner is working in
be expecting barcodes as long as it is seated in the Auto-sense stand. Whenever a
barcode is brought within range, the scanner will be able to decode it.
To stop this mode, just remove the scanner from the stand.
You can determine the occasion for decoding destination barcodes. As the setting
barcodes shown below, "Detection By Barcode" means when an object is judged a
barcode, the scanner decodes the destination barcode. "Detection by Motion" means
when an object is detected moving, the scanner decodes the destination barcode.
Besides, users can determine the auto-sense detection level ranging from 0 to 7 (default
value is set to 4; greater number means higher detection sensitivity) when the scanner is
seated in the stand and set in the "Detection By Motion" mode.
1) Read the barcode above to specify the Auto-sense Detection level.
2) Read the "Decimal
Auto-sense Detection Level on 1.
3) Read the "Validate" barcode on the same page to complete this setting.
Value" barcode on page 227. For example, read "1" to set the
Chapter 1 Understanding the Barcode Scanner
Laser
*Enable
Disable
*Detection By
Barcode
Detection By Motion
Auto-sense
Detection Level 0~7
(*4)
Update
Mode. The scanner will
47