Send Data
The 4MB flash memory on the scanner can store up to 240,000 scans based on EAN-13 barcodes.
When it is used up, the scanner will respond with two short beeps (high-low tone) as a warning.
You are advised to send data to the host immediately by having the scanner read the "Send Data"
barcode below. It will resume the previous WPAN connection with the host temporarily.
Clear Data & Confirm
Even though data has been sent back to the host, the flash memory is still occupied unless you
erase the memory by having the scanner read two barcodes – "Clear Data" and "Confirm".
1.
Read the "Clear Data" barcode to clear the flash memory.
2.
Read the "Confirm" barcode to confirm the action.
1.2.3 FREE MEMORY
In memory mode, you can scan the barcode below to show the available capacity of the
flash memory in percentage terms.
Chapter 1
Understanding the Barcode Scanner
8 sec
Send Data
Clear Data
Confirm
Spare memory
Update
31