CipherLab 2560 User Manual page 82

2560 Series Barcode Scanner
Note: Read the "Set Connection" barcode first, and then the "MAC ID" barcode within 10
seconds.
Instead of producing the "MAC ID" barcode, you may have the scanner read the setup barcodes for
entering the MAC address.

Have the scanner read the "Abort" barcode to cancel the operation at any time while reading
setup barcodes for the MAC address. If the MAC address has not been completed yet, having
the scanner read the "Validate" barcode can cancel the operation as well.
Usage:
1. Read the barcode above.
2. Read the "Hexadecimal
3. Read the "Validate" barcode on the same page to complete this setting.
Connect with the target device by scanning a single 1D setting barcode
Users can produce a single 1D setup barcode that combines the "Set Connection" and "MAC ID" setup
commands to connect with the cradle. While producing the barcode, be aware the letter upper/lower
case "SeTcOn" and the barcode must be the Code 128 symbology.
Usage:
1) Read the "Activate Bluetooth
settings, such as authentication and preset PIN. Skip this step if no connection settings are
desired.
2) Read the "SeTcOnxxxxxxxxxxxx" 1D single barcode below. The scanner will respond with one
beep upon reading the barcode.
Exit SPP Master Mode
To stop such re-connection, read "Reset Connection" or "Restore System Defaults" barcode so that
the current connection record (= MAC ID) will be cleared. Then, the scanner will restart itself
automatically. Go through the process in
connection.
70
User Guide
Value" barcode on page 228 for the desired MAC address.
®
SPP, Master Mode" barcode above and barcodes for connection
3.2.3 Connect to Dongle
Reset Connection
Enter MAC ID in
Hexadecimal...
to establish a new WPAN
Enter Setup