Firmware Upgrade - CipherLab 2560 User Manual

FIRMWARE UPGRADE

You can only upgrade firmware of one scanner at a time. For example, you must turn off
each of the rest scanners when there is more than one scanner connected to your
computer.
Note: In case it fails downloading due to low battery, make sure the targe scanner is
loaded with good battery and the battery charge is enough.
HOW TO UPGRADE THE SCANNER FIRMWARE
USING BT CRADLE
1) Connect the interface cable, RS-232 or USB, between cradle and your computer.
For USB Virtual COM, you may need to install its driver first!
2) Connect the power supply cord from the cradle to a proper power outlet.
3) Refer to 3.1.1 Connect to Cradle
Read the MAC address label located at the back of the cradle.
4) Read the following barcodes in sequence to configure the cradle to use RS-232 as
download interface.
Or, read the following barcodes in sequence to configure the scanner to use USB
Virtual COM as download interface.
for the target scanner to connect to the cradle.
Enter Setup
Activate Cradle
115200 bps
Update
Appendix I
RS-232
Update
211