CipherLab 2560 User Manual page 38

2560 Series Barcode Scanner
Note: "Auto Power Off" will not take effect when the scanner is in the configuration
modee.
1.1.2.3 AUTO POWER OFF IGNORING SCAN MODE
This mode is intended only for Continuous Mode, Test Mode, and Alternate Mode. To
force a scanner that is set to one of these three modes to automatically power off to save
power, you need the following settings:
1. Enable "Auto Power Off" as detailed in the foregoing section
Off. And set a time for the scanner to automatically power off after power-on.
2. Enable "Auto Power Off Ignoring Scan Mode" by reading the barcode below:
Read the barcode above to enable/disable automatic power-off for Continuous Mode, Test
Mode, and Alternate Mode.
Note: "Auto Power Off Ignoring Scan Mode" only features enabling and disabling. It
doesn't feature the setting of auto power-off time. Such setting should be
configured in the preceding setup of "Auto Power Off".
26
User Guide
1.1.2.2 Auto Power
Enable
*Disable
Enter Setup