Inter-Character Delay - CipherLab 2560 User Manual

2560 Series Barcode Scanner
Digits Transmission
By default, the alphanumeric keypad is used for transmitting digits. Select "Numeric Keypad" if you
wish to use the keys on the numeric keypad.
Note: If you select "Numeric Keypad", the Num Lock status of the physical keyboard
should be "ON".

2.6.3 INTER-CHARACTER DELAY

By default, the inter-character delay is set to zero. Specify a value, ranging from 0 to
254 in units of millisecond, to match the computer response time of the keyboard
interface. Such delay time is inserted between every character being transmitted. The
longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-character delay.
2) Read the "Decimal
(millisecond).
3) Read the "Validate" barcode on the same page to complete this setting.
96
User Guide
Value" barcode on page 227 for the desired inter-character delay
Numeric Key
*Alphanumeric Key
Inter-Character
Delay... (*0~254)
Enter Setup