Mitsubishi M80 series Connection And Set Up Manual page 493

M800S/M80 Series Connection and Setup Manual
30 Data Backup and Restoration
The following two functions are available for the data backup and restoration: all backup function for files in batch and
input/output function for separate files.
The following devices are available in all backup and restoration.
Memory card (Front-side SD card)
DS (Back-side SD card of display unit)
USB memory
The master data backup and restoration are used for backing up and restoring the initial state data set by MTB. The built-
in memory is used for the master data backup and restoration regardless of the selected device.
Files to be backed up/ restored are as follows.
Screen display
System data
Ladder
Safety parameter
Safety ladder1
Safety ladder2
APLC data
Custom data
For the input/output function for separate files, refer to the Instruction Manual.
IB-1501269-F
File name
SRAM data (binary files)
SRAM.BIN
Programs, parameters, R registers and so on
Parameters
ALL.PRM
(*) These data can be backed up only, cannot be restored.
System configuration
ASSEMBLY.INF
(*) These data can be backed up only, cannot be restored.
USERPLC.LAD User PLC program
SAFEPARA.BIN Safety parameter (binary file)
SAFEPLC1.LAD Safety PLC program1
SAFEPLC2.LAD Safety PLC program2
APLC.BIN C language module created by user
Custom screen data
- (Custom screen modules, setting files (Config.ini/
customdef.ini/customload.txt) and PLC alarm messages)
456
Data type