Mitsubishi M80 series Connection And Set Up Manual page 302

Hide thumbs Also See for M80 series:

Table of Contents

M800S/M80 Series Connection and Setup Manual

13 Connection of MITSUBISHI CNC Machine Operation Panel

(Note 1) Wirings for memory protection switches must be directly soldered to terminals or use tab

(Note 2) When wiring the emergency stop switch, the crimp terminal must be fastened with thread.

(Note 3) For NCs whose control unit and display unit are integrated, wire the emergency stop switch

(Note 4) Select a rotary switch which guarantees 5V/1mA.

(Note 5) Length of cables must be 0.5m or shorter.

(Note 6) The numbers in the above diagram do not indicate the actual device numbers.

Main panel A/B (FCU8-KB92x)

terminals (110 series).

directly to the EMG connector of the control unit. (Use J121 cable)

For a separated-type NC, wire it directly to the EMG connector of the operation panel I/O unit.

Sub panel A (FCU8-KB931)

Switch input spare

Spare for signal relay

Memory protection switch

2 notch Key shape

2c Manual return type

Push down switch

(For emergency stop)

2a2b contact

IB-1501269-F

Show Quick Links

Table of Contents

M800s series