Install Oil Filter - Rotax 912 iSc Maintenance Manual

To mount the oil filter the following steps are necessary:
Procedure
Step
1
2
3
4
5
6
7
Inspect all systems for correct function.

Install oil filter.

Graphic
Fig. 21
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Unscrew the oil filter with the oil filter wrench
Clean the contact surface (1) of the oil pump housing (2) with a clean cloth.
Apply thin film engine oil on the gasket (3) of the oil filter (4).
Install the oil filter on the engine.
Screw on oil filter until oil filter gasket is seated solidly.
NOTE: Mark 270° - check mark on oil pump housing to control tightening
of oil filter.
Tighten oil filter with 3/4 turn (270°).
Inspection of the used oil filter. See chapt. 12-20-00 section:
Part
1 Contact surface
2 Oil pump housing
3 Gasket
4 Oil filter
Procedure
Function
12-20-00
12.3.2).
page 39
January 01/2012