Install Oil Filter - Rotax MML-912 Maintenance Manual

11.4) Install oil filter

See
General note
To mount the oil filter the following steps are necessary:
Procedure
Step
1
2
3
4
5
Inspect all systems for correct function.
Install oil filter.
Graphic
Fig. 25
Effectivity: 912 Series
Edition 2 / Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Fig. 25.
After test run inspect tight fit of oil filter.
NOTICE
WARNUNG
Clean the contact surface (1) of the oil pump housing (2) with a clean cloth.
Apply thin film engine oil on the gasket (3) of the oil filter (4).
Install the oil filter on the engine.
Screw on oil filter until oil filter gasket is seated solidly.
Tighten oil filter with 3/4 turn (270°).
1
4
B
Part
1 Contact surface
2 Oil pump housing
3 Gasket
4 Oil filter
Procedure
3
A
4
2
4
Function
C
08550
12-20-00
page 51
October 01/2009