Rotax 912 iSc Maintenance Manual page 39

No.
16
17
18
19
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
part no. Description, Application
n.a. Cleaning agents
NOTICE
Do not use lye-based cold cleaner or degreasing
agents. Do not clean coolant or oil hoses with
aggressive solutions. Clean off sealing com-
pound residue with sealant remover.
Soak combustion chamber, piston and cylinder
head with cleaning agent and remove combus-
tion residues with a bronze brush. Very good re-
sults have been achieved with "Clenvex 2000".
It is a solvent-cold cleaner, free of halogen, on
the basis of selected fuel fractions with tensides
and is biologically disposable.
Never use caustic or corrosive cleaning agents.
n.a. MICRONORM abrasive
This abrasive is suitable for local and gradual
very fine treatment of steel parts with rust film
(propeller shaft). The MICRONORM abrasive
contains no noxious matter, is approved by the
relevant authorities and guarantees optimum
cleaning. The granulates used are of sizes 40 to
60 µ. It is possible to achieve a surface rough-
ness of 0.5 to 1µ, which represents fine process-
ing of surfaces.
n.a. LOCTITE 7063
Degreasing fluid. For parts cleaning before appl-
cation of adhesives and sealants.
898351 KLUEBER ISOFLEX TOPAS NB 5051
Is a beige-coloured, homogeneous, short-fibred
long-term grease for a wide service
temperature range. It is a dynamically light
grease consisting of synthetic hydrocarbon oil
and barium complex soap. Appropriate to
European-Norm the needed barium complex
soap is not harmful to health.
ISOFLEX TOPAS NB 5051 ensures low,
uniform starting and running torques. In
addition, it is resistant to oxidation and ageing,
and protects reliably against corrosion.
Use only approved cleaning
agents (e.g. kerosine, varsol,
etc.) for cleaning all metal
parts.
Qty.
500 g (1.1 lb)
05-00-00
page 11
January 01/2012