Rotax 912 iSc Maintenance Manual page 120

Step
12
13
Engine oil and
coolant
Replenish engine oil and coolant as required once engine has cooled
down.
Oil filter
Inspect the engine for oil, fuel or coolant leaks and repair as necessary.
Check of leaks
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
After full-load run, conduct a short cooling run to prevent formation of vapour
lock in cylinder heads. This is necessary to prevent steam locks in the cooling
and fuel system after shut-down.
Shut engine down.
NOTE: On switching off the engine switch off ignition and withdraw
the ignition key.
Risk of Burns!
WARNUNG WARNING
Never open the radiator cap when the cooling system
is hot. For safety's sake, cover cap with a rag and open
slowly. Sudden opening of the cap could provoke the
escape of boiling coolant and result in scalding.
If the oil filter has been replaced, re-tighten by hand af-
NOTICE
WARNUNG
ter the trial run on a cold engine.
Procedure
12-20-00
page 18
January 01/2012