Oil Filter Replacement And Inspection - Rotax 912 Series Maintenance Manual

5.3)

Oil filter replacement and inspection

See fig. 16, 16/1 and 17.
Unscrew oil filter with filter wrench, part no. 877 620* .
At every oil change, replace the oil filter and open the old one with special tool,
part no. 877 670* thus not producing chips.
zur Lagerstelle /
to bearings
00349
fig. 16
Remove filter insert, cut top and bottom edges off the mat. Remove filter mat,
unroll and inspect it for metal chips, foreign matter, contamination and abrasion.
This inspect is important as it allows conclusions regarding the condition of the
engine and gives information about a possible cause of any failure.
WARNING: Always allow engine to cool down to outside air temperature
* or equivalent
Effectivity: 912 Series
AIRCRAFT ENGINES
MAINTENANCE MANUAL
von der Ölpumpe /
from oil pump
before start of any work.
Severe burns and scalds may result if this is not respected.
fig. 16/1
02734
12-00-00
Rev. 1, Jan. 01/2002
page 30