Oil Filter Replacement And Inspection Of The Filter Insert - Rotax 914 Series Maintenance Manual

5.3)

Oil filter replacement and inspection of the filter insert

▲ WARNING: Always allow engine to cool down to ambient temperature
See Fig. 34, 35 and 36.
Unscrew oil filter with filter wrench part no. 877620*.
At every oil change, unscrew the oil filter and cut open using special tool
part no. 877670* taking care not to produce chips.
00349
Fig. 34
Remove filter insert, cut top and bottom edges off the mat with a knife. Remove
filter mat, fold up and press remaining oil out. Unroll and inspect it for metal chips,
foreign matter, contamination and abrasion.
This inspection is important as it allows conclusions to be drawn regarding the
internal condition of the engine and provides information about the possible
cause of any damage.
* or equivalent
Effectivity: 914 Series
Edition 1 / Rev. 0
BRP-Rotax
MAINTENANCE MANUAL
before start of any work.
Severe burns and scalds may result if these instructions are
ignored.
von der Ölpumpe /
zur Lagerstelle /
from oil pump
to bearings
02734
Fig. 35
12-00-00
page 38
May. 01/07